#30274 ejector upgrade

I'm thinking of trying the Jager Gen 4 guide rod assembly which will allow me to run a reduced rate spring. This ejector tab is a direct fit replacement into any generation trigger housing for improved ejection patterns, especially brass to the face.

#30274 ejector upgrade

This upgrade solves many of the ejetion issues with the Gen 3 ejectors. Included with the kit which sets it apart from all the other kits available. 380 Auto & 9mm Slim (G42, G43, G43X, G48) 8.50. Reviews (8) Our Gen 4 style Glock 9mm Ejector is a direct drop in replacement for your gen 3 ejector. Resolves erratic ejection patterns notorious with the gen 3 ejector. 54 product ratings - Genuine Glock Trigger Housing Ejector 30274 fit 9mm 17 19 26 34. Glock Trigger Mechanism Housing w/ Ejector Marked 33214. The question is, what now? I'm almost thinking that the dual recoil spring is sprung too heavy, thus the rounds weakly arcing up and landing on my right arm and such. Glock Trigger Mechanism Housing w/ Ejector Marked 30274, 9mm (Gen4) 8.50. I also installed a drop in trigger from which included a new but different 30274 ejector but it didn't change a thing. For 9mm Models G17 G19 G26 G34 Only (NOT FOR G43, G43X, G48, Gen 5) Fits Any 9mm Polymer80 lower build. Gen 4 housing Customized to fit Generations 1/2/3/4.

GENUINE GLOCK TRIGGER HOUSING STOP FOR 9MM. I get hit almost every round, it's crazy. Fully adjustable over travel steel set screw modification. However I shot another 115 rounds of the same loads today, and I still get brass landing on my right arm, hitting me in the head, and now hitting me in the center of the chest. These parts were supposed to be the magic cure for the ejection issue. I installed the Apex failure resistant extractor along with the included stronger spring and non-loaded chamber indicator bearing. If this is your first visit, be sure to check out the FAQ by clicking the link above. My loads are 130 ish power factor, shooting 4.0-4.1 grains of N320 below a 124 JHP MG bullet. The gun had all the newest parts such as the 0-4-3 recoil spring assembly, dipped extractor, and 30274 ejector. I would also get the occasional case hitting me on top of the head. Shooting the first 150 rounds through it, I was getting weak ejection with the majority of the rounds landing on my right bicep/forearm (i'm right handed).

I have a newer July 2013 production Gen 4 Glock 19 that has a bad brass to face problem.